Operating Procedures for roller presses
1, The operation, the roller should start before the earthquake, internal combustion engine should first as the medium speed, and then modulated high-speed.
2, Variable speed and commutative should be the first shutdown, variable speed should reduce the speed of the internal combustion engine.
3. It is strictly forbidden for the roller to vibrate on a solid ground.
4, Milling soft subgrade, should first in the case of non-vibration to crush the 1~2, and then vibration milling.
5, When rolling, vibration frequency should be consistent.For the adjustable vibration roller, you should first adjust the vibration frequency before working, not in the case of no earthquake adjustment vibration frequency.
6. The adjustment of the commutative clutch, the starting clutch and the brake shall be carried out after the main clutch is removed.
7, Up, downhill, can not use the fast gear.In sharp turns, it is strictly forbidden to use the fast gear when the articulated vibrating roller is crushed in a small turn around the circle.
8. The roller shall not join the vibration when driving at high speed.
9, The shutdown should first stop the vibration, and then the commutative mechanism placed in the middle position, the transmission placed in the gap, and finally pull up the brake joystick, the internal combustion engine idle operation for several minutes after the shutdown.
10, Other operating requirements should conform to the provisions of static pressure roller.
① Whether uphill or downhill, the next layer of asphalt mixture must be clean and dry, and must be sprayed with asphalt bonding layer to avoid mixing the mixture during milling.
② Whether it is uphill milling or downhill milling, the drive wheel of the roller should be in the back. This has the following advantages: When uphill, the rear drive wheel can withstand the ramp and the machine itself to provide the driving force, while the front wheel on the road surface initial compaction, in order to withstand the driving wheel produced by the larger shear force; downhill, the impact of the roller's self-weight is offset by the braking of the drive wheel,Only the mixture after rolling through the front wheel has the ability to support the shear force of the rear drive wheel.When the
③ Uphill, the roller starts, stops and accelerates smoothly, avoiding too high or too low a speed.
④ Before uphill rolling, the mixture should be cooled to the specified low temperature, and then static preloading, until the temperature of the mixture to the lower limit (120 ℃), the use of vibration compaction.
⑤ Downhill milling should avoid sudden variable speed and braking. ⑥ when the slope is very steep to run downhill, the light roller should be used first to pre-pressure, and then with heavy-duty roller or vibrating roller compaction.







