Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

The chain of excavator has fallen off. How can it be installed quickly?

When excavators work, the track chain board often falls off. Especially when they drive a machine for a long time, the operators who are not experienced enough often have no countermeasures.            

There are two commonly used methods of mounting track link:            

Method 1,            

When one side of the track falls off, to clean up the debris around the track, the driving wheel must be docked first, and the upper track should be lifted with a bucket. At the same time, the driving wheel should be aligned and entered into the track, and the driving teeth should be aligned with iron rods when getting off, and the upper tugboat should be aligned. This step has been completed by one third.            

One-sided walking of the machine to straighten the track, once again to support the machine and get off to adjust the lower track, try to align the track with the supporting wheels after the track falls (this is a step that Jiayou easily overlooked), by this step has been completed by two-thirds.           

Just lift the excavator gently with bucket teeth and lift the track so that the guide wheel enters the track, then adjust the track alignment guide wheel, then rotate the track and add butter, then the track has been assembled.

TRACK CHAIN

Method 2: Turn the loose pin joint of the chain to the middle height of the two ends and knock it out. At this time, the track board can be laid flat and in a zigzag shape. The excavator moves unilaterally to the upper part of the track.            

At this time, we need an iron rod to "guide" the track board to the "right track".           

From the start of the assembly of the driving wheel, with iron rods placed under the track board, supporting the machine to rotate the track, at this time also need a person in the cab to operate walking, while lifting the track at the same time turning the track forward;            

After traveling to the position of the guide wheel through the upper supporting wheel, an object can be placed at the guide wheel. At this time, the two sides of the caterpillar track are joined and the movable pin shaft can be assembled.            This method is also suitable for rubber caterpillar assembly. Because of the aging of live pins, knocking is difficult, and even requires welding and cutting equipment to assemble, this method is not recommended in general.

You Might Also Like

Send Inquiry