Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

The characteristics and classification principle of quick change connector

Characteristics

1, Disassembly quickly and conveniently, save time and improve work efficiency, reduce the labor intensity of operators.

 2. There is almost no working medium outflow when the self-styled quick change connector is removed.The pollution of the working environment is reduced and the dirt is prevented from entering the piping system, thus improving the reliability of the hydraulic system.

3, Quick change connector itself can be freely rotated, not only to release the installation process in the pipeline generated by the internal stress, but also to overcome the work due to vibration caused by the loosening.

4, The use of high-strength materials, suitable for 3-45 tonnage of various models.

5, The use of liquid-controlled one-way valve safety device, to ensure safety.Hydraulic principle Hydraulic quick change joint is mainly based on the cylinder dynamic hydraulic quick change connector for the pin shaft 1, 2 for fixing and loosening. When the working parts need to be replaced, the cylinder retracts, the hook-shaped pressure block from 1 position movement to 2 position, quick Change Connector detachment, switch to other working parts, hook type pressure block on the good pin shaft, the cylinder then open, hook pressure block from 2 position movement to 1 position, the work accessories PIN shaft lock.Of course, there are external oil and solenoid valves working at the same time.

Mechanical principle Mechanical Quick Change Connector domestic manufacturers of products are mainly divided into two types, a plug-in mechanical quick-change connector pin, a screw type. Take the plug type as an example, when the need to replace the working parts, the wedge card is first pulled out, the T-buckle into the ring, (T-buckle can very smoothly drive the red part of the pressure to recycle, here in the face of high welding requirements, the slide is not welded flat, while grinding is not clean point, red part of the pressure block action ) Quick change connector and bucket detachment.When changing to the required working part, the T-buckle pulls back and the wedge card is inserted into the T-clasp for locking.


You Might Also Like

Send Inquiry