Working Principle and Damage Cause of Front idler roller
The working principle of the idler roller assembly is as follows: the butter is injected into the butter cylinder through the butter nozzle with a butter gun, so that the piston extends to push the expansion spring, so that the guide wheel moves left to tighten the caterpillar. The tightening spring has an appropriate stroke, and when the tightening force is too large, the spring is compressed to cushion the effect; after the excessive tightening force disappears, the compressed spring pushes the guide wheel to the original position, so as to ensure that the guide wheel is in place. Slide along the crawler rack to change the wheel spacing, ensure the disassembly and assembly of the crawler, reduce the impact of the walking process, and avoid derailment of the track chain.
The main reason for the damage of the idler roller is the poor lubrication of the idler roller shaft. The main reasons are as follows:
The bimetal sleeve sliding bearing of the guide wheel has different oversize axes, and the track assy runs with vibration and impact. Once the geometric dimension is oversize, the gap between the guide wheel shaft and the sleeve will be too small or no gap, and the thickness of the lubricant film is not enough or even no lubricant film.
Surface roughness of guide axle is over-tolerance. There are many metal prisms on the surface of the shaft, which destroy the integrity and continuity of the lubrication film between the shaft and the sliding bearing. When working, a large number of metal debris will be produced in lubricating oil, which will increase the surface roughness of the shaft and bearing, worsen the lubrication condition, and cause serious wear of guide axle and sliding bearing.
The original structure is defective. Lubricating oil is injected from the screw plug hole at the shaft end of the guide wheel, and then gradually fills the whole cavity. In practice, if there is no special tool for oil injection, it is very difficult for lubricating oil to pass through the circuitous cavity of the guide wheel only under the action of its own gravity, and the gas in the cavity is not expelled smoothly, so the lubricating oil is difficult to fill. The oil filling space of the original engine chamber is too small, resulting in a serious shortage of lubricating oil.
Lubricating oil in the gap between guide axle and bush can not take away the heat generated by the bearing because there is no oil passage. As a result, the working temperature of the bearing increases, the viscosity of the lubricating oil decreases, and the thickness of the lubricating oil film decreases.







