Hyundai Excavator/Bulldozer Track Roller Ex60-1

The advanced technology and equipment and mature management mode we adopt can fully guarantee the high standard and high quality of our Track Roller R130, Bulldozer Track Roller Group, Front Idler EX120-2 EX120-3 EX120-5. Be a part of us and let's make driving safer and funnier jointly! Our company has been praised by customers for its outstanding strength, excellent quality, reasonable price, and perfect service. We have maintained a good relationship with many merchants, and our business is all over the world.

Track roller for Hitachi excavator:

The track roller is used to support the weight of the tractor and roll on the track (rail chain) or track shoe. It is also used to limit the track and prevent lateral slippage. When the tractor steers, the track rollers force the track to slip on the ground.

Excavator lower rollers are often in mud, water and dust, and bear strong impact. Therefore, they are required to be sealed reliably and wear-resistant.

Types:

The type of excavator bottom rollers used in combination track is different from that used in integral or rubber track: the supporting wheels of combination track roll on the guide rail while the supporting wheels of integral or rubber track roll on the track board.

There are two types of down roller for combined track, as shown in the following figure.One is single flange, the other is double flange. The former is easy to manufacture, so it is more widely used, while the latter is less used. The purpose of flanges is to prevent the relative lateral movement of the track against it, so as to prevent derailment when turning. Usually the height of flange H = 10-20 mm. In order to reduce the friction between the flange side and the guide rail side, the flange side is often made into an inclined plane with a slope angle of 20 ~30 degree.

Integral or rubber track, because the inner surface of the track board is cast with raised Chlamys to prevent the lateral movement of the track to the supporting wheel, so its supporting wheel flange is straight without flange. But each supporting wheel must have double-row rims, as shown in the figure below.

The number of supporting wheels can make the grounding pressure of the track more uniform, so that walking on the wet and soft soil can reduce the subsidence, but on the other hand, because the length of the track is certain, the number of supporting wheels is more, the diameter of each must be small, which increases the rolling resistance, generally speaking as a combine harvester. The number of supporting wheels is usually 3 to 4, and a few of them are 6.

The diameter of the supporting wheel D and the pitch P of the track shall be roughly maintained in the following proportion.

Combination track D/P=1-1.5

For integral or rubber trackD/P=1.5-3

Sliding bearings (such as iron-based powder metallurgy oil bearing) are commonly used for supporting wheels, but rolling bearings are also useful.No matter which bearing is used, it is necessary to prevent mud from entering. The flange of the supporting wheel should be wear-resistant. It is generally made of 50mn steel. The hardness of the flange surface after quenching is no less than HRC53.

 

 

 

We provide professional and high-quality complete Hyundai Excavator/Bulldozer Track Roller Ex60-1 and solutions for various customers. Technical elites have accumulated rich experience in research, development and marketing for the company and constantly push the old and bring forth the new to meet the requirements of different customers. Welcome you to cooperate with us and join us.

Hot Tags: Track Roller For HITACHI EX60-2, China, best, manufacturers, suppliers, factory, reusable bolt, carrier roller for freezing equipment, skid steer attachments for sale, long bolt, front idler in power generation equipment, titanium bolt