Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

How to lower the wear of bucekt pin

The wear process of bucket pin can be divided into three stages: running-in stage, abrasive wear stage and bond wear stage. The first stage: in the running-in stage of bucket axle sleeve, proper amount of lubricating grease should be added, too much or too little pressure injection will affect the establishment of bucket axle balance roughness, thereby affecting the service life of bucket pin; the second stage: the working environment of excavator is dusty and muddy, while the structure of bucket axle sleeve of excavator is simple, axial and axial. The radial clearance is relatively large, and abrasive grains such as sand, gravel and clay easily enter the contact area of the bucket shaft hole, scratch the surface of the parts and form abrasive wear. The third stage: after a long period of frontal abrasive wear, the hardened layer begins to fall off, the lubrication effect decreases, and the long period of heavy load causes greater tangential force, which finally causes the breakdown of the adsorption film. The bonding phenomenon occurs on the new surface after wear, and the bonding wear marks the end of the life of bucket pin.            

There are many hinges on the working device of excavator. When working, the bucket shaft and sleeve rotate relatively and transfer load is large. The reasonable choice of the clearance between bucket shaft and sleeve directly affects the reliability of excavator. If the fit clearance is too small, it will not form a stable lubricating oil film, which will cause direct contact between the shaft and the sleeve, heat generation and wear, even dry grinding, locking and fracture. If the clearance between the pin and the bush is too large, the contact stress between the shaft and the sleeve will increase, and the service life of the shaft and sleeve will be affected.

You Might Also Like

Send Inquiry