Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

Three Secrets to Teach You to Reduce Wear of Track Shoe of Excavator

The walking part of excavator is composed of track roller, carrier roller, sprocket rim and track chain. When it runs for a certain time, these parts will be worn to a certain extent. However, if we pay attention to daily maintenance, as long as we spend a little time on proper maintenance, we can avoid the future "excavator leg surgery". Not only can you save money for maintenance, but also avoid delays due to maintenance.

First point: If we repeatedly walk on the inclined ground for a long time and turn suddenly, the side of the chain joint will contact the side of the sprocket rim and the idler, thus increasing the wear degree. Therefore, walking and sudden turning should be avoided as far as possible in inclined zones. Linear travel and large turning can effectively prevent wear and tear.            

Second point: If some of the sprocket rims and carrier roller can not be used in operation, it may lead to wheel grinding deviation, but also may cause track chain wear. If you find a roller that can't work, it must be repaired immediately! In this way, other faults can be avoided.          

Third point: the track roller,carrier roller installation bolt, track plate bolt, sprocket installation bolt, walking pipe bolt and so on, because the machine is easy to loosen due to vibration after a long time of work. For example, if the trakc bolt is loosened and the machine continues to operate, it will even lead to the gap between the track shoe and the bolt, which will lead to the crack of the track pad. Moreover, the gap may also increase the bolt holes between the track shoe and track chain, resulting in the serious consequences that the track shoe and track chain cannot be tightened and must be replaced. Therefore, bolts and nuts should be regularly inspected and tightened to reduce unnecessary maintenance costs.

You Might Also Like

Send Inquiry