Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

A Good Method to Reduce Track Wear of Excavator

As we all know, the walking part of excavator is mainly composed of sprocket rim, carrier roller,track roller and track link. Each operation is indispensable to operate, therefore, after a certain period of operation, these components will appear varying degrees of wear and tear. Here, we share some daily maintenance methods, which can reduce the wear and tear of excavator crawler, and avoid future failures. It also takes a lot of time and energy to repair.            

Method of reducing wear and tear of excavator's moving parts            

First point: If the wheel is found to be out of operation due to malfunction, it should be repaired immediately.      If there are some supporting sprockets or supporting wheels that can not continue to operate, in such a state to continue to use, it may cause wheel grinding deviation, or even lead to rail chain wear. Therefore, when the roller can not run, it must be repaired immediately, so as to avoid other faults in time.            

Second point: Avoid excavators moving on inclined ground or turning abruptly as far as possible.            Repeated walking and sudden turning on inclined ground for a long time will cause the side of rail chain joints to the side of driving wheel and guide wheel, which will increase the degree of wear and tear. Therefore, in the process of operation, as far as possible to choose straight line travel and large turning, can effectively prevent excessive wear and tear.            

Third point: Regular inspection and reinforcement of bolts and nuts can effectively reduce track wear.            Supporting wheels, caterpillar plate bolts, driving wheel mounting bolts, running piping bolts, etc., are easy to loosen due to vibration due to long-term work of the equipment. If the crawler plate bolts are loosened and the equipment continues to operate, the gap between the bolts and the crawler plate may occur, resulting in cracks in the crawler plate. The gap may also increase the bolt holes between the track and the rail link, resulting in no way to tighten, resulting in the consequence that the track and rail link must be replaced.            Although the excavator crawler wear is caused by some minor details, but it is these minor details, if not paid attention to may lead to major failures and consequences.

You Might Also Like

Send Inquiry