Quanzhou Sanqi Engineering Machinery Co.Ltd

enLanguage

Reasons for Damage of Idler Roller of Bulldozer?

The main reasons for the damage of the idler roller are the poor lubrication of the guide wheel axle. The main reasons are as follows:            

  1. The bimetal sleeve sliding bearing of the guide wheel has different oversize axes, and the crawler runs with vibration and impact. Once the geometric dimension is oversize, the gap between the guide wheel axle and the sleeve will be too small or no gap, and the thickness of the lubricant film is not enough or even no lubricant film.           

  2. Surface roughness of guide axle is over-tolerance. There are many metal prisms on the surface of the shaft, which destroy the integrity and continuity of the lubrication film between the shaft and the sliding bearing. When working, a large number of metal debris will be produced in lubricating oil, which will increase the surface roughness of the shaft and bearing, worsen the lubrication condition, and cause serious wear of guide axle and sliding bearing.           

  3. The original structure is defective. Lubricating oil is injected from the screw plug hole at the shaft end of the guide wheel, and then gradually fills the whole cavity. In practice, if there is no special tool for oil injection, it is very difficult for lubricating oil to pass through the circuitous cavity of the guide wheel only under the action of its own gravity, and the gas in the cavity is not expelled smoothly, so the lubricating oil is difficult to fill. The oil filling space of the original engine chamber is too small, resulting in a serious shortage of lubricating oil.           

  4. Lubricating oil in the gap between guide axle and bush can not take away the heat generated by the bearing because there is no oil passage. As a result, the working temperature of the bearing increases, the viscosity of the lubricating oil decreases, and the thickness of the lubricating oil film decreases.


You Might Also Like

Send Inquiry